Shopping Cart
Range of Motion (ROM) Hinge Assembly with ROM Connecting Rods

SK Range of Motion (ROM) Hinge

 

SK Range of Motion (ROM) hinges are modular by design and the hinge rods are easily interchanged to accommodate different limb length and patient anatomy.

Additional Product Information

ROM hinges should be reserved for experienced surgeons in challenging situations. Often simpler methods are available such as modified SK clamps for transarticular frames or modified angular hinges from the CESF system.

To change rods, loosen the corresponding nut or nuts and unscrew the rod from its mating hinge pin. This can usually be done by hand but a pair of pliers can be used if needed. Since the hinge pin is held in position by the rod, it must be positioned before screwing in the replacement rod. Rod insertion into the hinge pin can be achieved from one direction only; therefore, it is necessary to seat the hinge pin properly to ensure correct rod insertion.


  • Specifications
  • Learn
  • FAQs
  • You Might Also Like


Product Specifications

Part No. Compatible System Included Rod Lengths Overall Length Rod / Thread Diameter Wrench Size Accepted
Part No. Compatible System: Small linear Included Rod Lengths: 75 mm, 100 mm2.953 in Overall Length: 185 mm7.283 in Rod / Thread Diameter: 6.3 mm / 6 mm0.236 in Wrench Size Accepted: 10 mm0.394 in
Part No. Compatible System: Large linear Included Rod Lengths: 100 mm, 150 mm3.937 in Overall Length: 260 mm10.236 in Rod / Thread Diameter: 9.5 mm / 8 mm0.354 in Wrench Size Accepted: 13 mm, 15 mm0.512 in